Determine the inlet water pressure first. Maintain the hose with compressive pressure. The ideal home water pressure should be measured at about 50 psi. If the pressure is too high, install a pressure reducing of the Safety Relief Valves Suppliers. Attach the pressure gauge using threaded pipes and fittings, the initial phase of pressure reduction on each side.
- Keep the pressure to reduce the valve assembly against the water pipe to draw the pipe cutting mark.
- After turning off the main body of water, drain the water from the piping system.
- From the mark made in step 4, use a hose cutter to remove the water pipe section.
- Remove both the pressure gauge and the rubber O-ring from the valve assembly.
- The brush fluxes the valve assembly at the end of the water pipe.
- Solder valve assembly for water pipes as part of a piping system made of copper.
- After assembly cooling, reinstall the pressure gauge and O-rings.
- Take a reading of the pressure gauge placed on the outlet of the valve after turning on the water.
If the water pressure is above 50 psi (very high), the adjustment screw on the valve must be rotated counter clockwise as mentioned by the Pressure Safety Valve India. On the other hand, if the water pressure is less than 50 psi (very low), the adjustment screw on the valve must be rotated clockwise.